Pivot hinge templates
For the mortises used to fit top and bottom pivot hinges in a door.
What to send
- The pivot maker's installation drawing
- The length, width and depth of each mortise
- The pivot point, measured from the hinge side of the door
- The door thickness and material
Mortises over 300 mm are machined in sections.
Fitting top and bottom pivots
The top and bottom mortises must share the same pivot line, so mark each centre from the same edge. The machine needs room to clamp securely at the cut, which may mean taking the door down. Say if you also need a recess in the frame, so access can be checked.
New to the machine? See how to use it and compare the two editions.