A portable CNC. Not just for door locks.
Door locks are where it starts. Cut hinge recesses, fit top and bottom pivots, then keep going. Hold the work securely and the same three axes, templates and software can serve many more ideas.
If you can fix it in place, you can think bigger.
Tell us your ideaPrecise
The program controls the position, shape and depth of every cut.
Reusable
Save the job once, then run the same template again and again.
Beginner-friendly
No steady hand needed. Beginners can cut well too: mark, clamp and press start.
Ready for batches
Use one template for door after door, or part after part.
Change the cutter. Change the material.
- Wood
- Aluminium
- Iron
- Steel
- Acrylic
Use the right drill bit or cutter for each material. Speed and depth per pass depend on the material, its thickness and the edition, so run a test piece first.
There is plenty of room to do more
- Door locksLock bodies, cylinders and handle holes.
- HingesRecesses for butt hinges and pockets for concealed hinges.
- Pivot hingesMortises for fitting top and bottom pivots in the door.
- Your own ideasHoles, slots, pockets and cut-outs. There is plenty of room to do more.
Ideas to start with
| Wood | Furniture joints, cabinet hardware pockets, hinge recesses and slots |
|---|---|
| Aluminium | Holes and slots in profiles, window and door sections, and panels |
| Iron and steel | Holes, slots and cut-outs in plate and brackets |
| Acrylic | Openings in panels, display parts and simple shapes |
| Repeat work | The same hole pattern or pocket across a batch of parts |
These are project ideas. The videos on this site show cuts in wood-finish doors, a metal door and thin stainless plate.
Will my idea work? Check three things.
- Can it be held securely? The machine and the work must not move during the cut.
- Is it within reach? The main travel is 300 mm, with longer work done in sections. The clamp range is 0–250 mm and the depth is up to 150 mm, depending on the cutter.
- Is the cutter right? It has to suit the material, depth and shape.
Not sure? Send a sketch with the material and thickness, or read about choosing cutters.