1000 W
Portable CNC Lock Mortising Machines
A precise, repeatable three-axis portable CNC, for door locks and much more.
Clamp it to the door, cut the pocket in the edge, then swing the cutting assembly round to cut the face. The touchscreen runs saved files.
If you are a locksmith, carpenter or door installer who fits locks, butt and concealed hinges, or pivot hinges, this machine is built for that work. New to CNC? Beginners can cut well with it too. And it is not just for locks.
- 300 mm main travel, with longer cuts made in sections
- 0–250 mm clamp range
- Up to 150 mm deep, depending on the cutter
Choose an edition below, or read the three short guides.
No products match. Choose another filter.
Trim router brands are not affiliated with Swivdor or the manufacturer. Fitting a router to a machine may affect the warranty given by its maker.
Precise
The program controls the position, shape and depth of every cut.
Reusable
Save the job once, then run the same template again and again.
Beginner-friendly
No steady hand needed. Beginners can cut well too: mark, clamp and press start.
Ready for batches
Use one template for door after door, or part after part.
Change the cutter. Change the material.
- Wood
- Aluminium
- Iron
- Steel
- Acrylic
Use the right drill bit or cutter for each material. Speed and depth per pass depend on the material, its thickness and the edition, so run a test piece first.
What can the lock mortising machine cut?
- Mortise lock and smart lock bodies in the edge of the door
- Euro cylinder, handle and fixing holes in the face
- Butt hinge recesses and concealed hinge pockets
- Mortises for top and bottom pivot hinges
- Mortises longer than 300 mm, machined in sections
- Holes, slots, pockets and cut-outs in other work that can be held securely
For metal, send the grade and thickness with your request, so the cutter and edition can be matched to it. See the test cuts.
CNC mortiser, electric mortiser or mortise lock jig?
| Drill and mortise lock jig | The jig guides a drill. You feed and reposition it by hand. A low-cost choice for occasional installs. |
|---|---|
| Electric lock mortiser | A motor drives the cutter. On hand-fed models you set the limits and work the cutter through the pocket. |
| This CNC mortiser | A program drives three axes from a saved template, for the edge pocket and for the holes in the face. |
If you fit the same locks often, start with the size and fit check, then see how templates work.
